8.4.2 Emergency brake release in case of air leak
•
It is possible to release the brakes of the machine using special brake release bolts in case of
a leak of air from the brake system.
•
The bolts are included in the installation unit of the brake cylinder.
Emergency brake release procedure in case of air leak
•
Remove the bolts from the holders of the brake cylinder (Fig. 1 and 2).
•
Release the cap on the back side of the brake cylinder (Fig. 3).
•
Insert the bolt by its flat end (T-shape) into the opening in the cylinder and turn the bolt by
90° at the end of the opening so that the screw is arrested and cannot be pulled out (Fig. 4).
•
Turn the nut (19 mm spanner) clockwise (Fig. 5). ATTENTION: Maximum torque is limited to
68Nm.
38
|
61
Summary of Contents for FANTOM 650 PRO
Page 2: ...2 61 Prepared by Technical Department Farmet a s on 31 05 2017 changes reserved...
Page 4: ...PREFACE 4 61 IMPORTANT READ CAREFULLY BEFORE USE KEEP FOR FUTURE REFERENCE...
Page 17: ...WORK SAFETY LABELS FANTOM 800 PRO FANTOM 850 PRO 17 61...
Page 31: ...COMMISSIONING Machine position for folding Machine position for unfolding 31 61...
