22
|
61
8 COMMISSIONING
•
Before taking over the machine, test and check, whether damage occurred during transport
and whether all parts contained in the bill of delivery were supplied.
•
Before commissioning the machine, carefully read this operating manual, especially Chapters
1–5
. Before the first use of the machine, familiarise yourselves with its controls and overall
function.
•
During work with the machine, observe not only the instructions of this operating manual but
also generally valid regulations of work safety, health protection, fire and transport safety,
and environmental protection.
•
The operator must check the machine before every use (commissioning) from the standpoint
of completeness, work safety, work hygiene, fire safety, transport safety, and environmental
protection. A machine showing signs of damage must not be commissioned.
•
Aggregation of the machine with the tractor is to be performed on a flat and hardened
surface.
•
When working on slopes, observe the lowest allowable slope grade of the set
TRACTOR -
MACHINE.
•
Before starting the tractor motor, check whether no person or animal is in the working space
of the set and push the warning sound signal.
•
The operator is responsible for the safety and all damage caused by the operation of the
tractor and the connected machine.
•
The operator is obliged to adhere to the technical and safety regulations of the machine
determined by the producer when working.
•
The operator is obliged to retract the working bodies of the machine from the ground when
turning at the headland.
•
The operator is obliged to observe the prescribed working depths and speeds stated in the
manual in. chap.
1
.
•
The operator is obliged to lower the machine to the ground and secure the set against
movement before leaving the tractor cabin.
DECREASE OF SOIL PRESSURE TO A VALUE LOWER THAN 200 KPA (29 PSI)
To decrease the specific pressure on soil (lower than 200 kPa / 29 Psi) at the turns on the
headland, raise the machine on the pole by using the hydraulic tractor shoulders and rear rollers.
Turn around when the machine is unfolded and resting on rollers.
Summary of Contents for FANTOM 650 PRO
Page 2: ...2 61 Prepared by Technical Department Farmet a s on 31 05 2017 changes reserved...
Page 4: ...PREFACE 4 61 IMPORTANT READ CAREFULLY BEFORE USE KEEP FOR FUTURE REFERENCE...
Page 17: ...WORK SAFETY LABELS FANTOM 800 PRO FANTOM 850 PRO 17 61...
Page 31: ...COMMISSIONING Machine position for folding Machine position for unfolding 31 61...
