6.2 Function of the closing (ball) valves
•
The machine is equipped with two closing (ball) valves and two switching (three-way) valves
inside the drawbar, see Fig. 2 and 3.
•
The external upper ball valve is used for closing the circuit for side frame unfolding (red
circuit); its use is further described in Chapter 8.3.
•
The external lower ball valve is used for closing the circuit controlling the piston-rods of the
transport axle (yellow circuit), its use is further described in Chapter 8.3.
•
The two ball switching (three-way) valves in the front part of the drawbar are used for
switching the function of the blue circuit. During operation, the blue circuit controls the flexi-
board (if installed) and the folding supporting leg of the drawbar.
• It is important to close the ball valves for transport !!!
Fig. 2 - closing (ball) valves
1.
Unfolding machine frames
2.
Locking/unlocking transport axle
3.
Switching (three-way) valves
Fig. 3 - Switching (three-way) valves
The switching valves in this position control the
flexi-board.
The switching valves in this position control the
supporting leg of the drawbar.
19
|
61
Summary of Contents for FANTOM 650 PRO
Page 2: ...2 61 Prepared by Technical Department Farmet a s on 31 05 2017 changes reserved...
Page 4: ...PREFACE 4 61 IMPORTANT READ CAREFULLY BEFORE USE KEEP FOR FUTURE REFERENCE...
Page 17: ...WORK SAFETY LABELS FANTOM 800 PRO FANTOM 850 PRO 17 61...
Page 31: ...COMMISSIONING Machine position for folding Machine position for unfolding 31 61...
