Manual
EXCELENT Premium 6; 8
45
│
52
When you empty the container, we recommend “sowing” a few metres with the empty machine and running fan
in order to remove the residues of seeds from the feeder and the whole system of the machine.
Prompt removal of the seed residues, especially when you do not use the machine for a longer period of time,
prolongs its usable life and prevents complications in the following operation.
8.
SUMMARY OF TASKS BEFORE THE COMMENCEMENT OF
WORK
-
Aggregate
the machine with the tractive equipment according to the instructions in Chap.3/str.12
-
Connect the hydraulics and electronics
of the sowing machine with the tractor
-
Turn on the display unit
and unfold the machine
-
Adjust the plane of the machine
– set the lower stop of the tractor three-point mounting, all hatches of
the rubber-tyred wheels must be set to the same height
-
Set the required data on the second display
– swathe of the sprayer, start of sowing, acoustic signals
-
Set the necessary sowing sample
– set the value on the turnstile according to the chart, turn on the third
display, fill up the sowing mechanism, set the number of M1 engine revs to zero, perform a trial sowing,
enter the value of the weighed sample, set the number of M2 engine revs to zero, perform a trial sowing,
enter the value of the weighed sample, switch to the basic display and execute sowing calibration
-
Set the priority
to the hydraulic circuit to which the hydraulic motor of the fan is connected
-
Set the air pressure to the value of
6-8 kPa
– by regulating the oil flow in the tractor
-
Pressurize the down pressure in the side frames – to the value of
30 bar EXC 6 ( 50 bar EXC 8 )
-
Set the required
hydraulic functions
– markers, marking rail lines etc.
-
Lower the front part of the machine by the tractor three-point mounting
during the drive
-
After that lower the rear part of the machine – when the machine is completely recessed, let the hydraulic
circuit run under pressure for 5-7 seconds and then set it to the
floating position!!!!!
-
Maximal working speed
according to the graph: sowing sample x speed x air pressure
-
When starting sowing in the corner of the land or when sowing the wedges, use the
presowing
function –
press the green arrow depicting the recess of the machine – this automatically starts the sowing (the
simulation of the tractor motion will start, which will replace the radar function) –
the machine must
start moving in 10 seconds!!!!!!
9.
MAINTENANCE AND REPAIRS OF THE MACHINE
Observe the safety instructions for maintenance and treatment.
Only persons according to Chapter
A.3
/p. 6 may perform repairs of the machine. When leaving the tractor
cabin, the operator must switch off all hydraulic circuits and appliances on the machine (ventilator) and the
engine and the operator must prevent unauthorized access to the tractor.
The replacement of worn shares can only be executed when the machine is standing still (not operating).
If you have to use welding during a repair and have the machine connected to the tractor, make sure that all
supply cables are disconnected from the alternator and accumulator.
Check that all screws and other assembly points are tight before each use of the machine and whenever
needed.
Regularly check the wear and tear of the working parts of the machine or replace the worn working parts with
new ones.
Adjusting, cleaning and lubricating the machine may only be performed when the machine is standing still
(the machine is stopped and is not working).
When the machine is lifted, use an appropriate supporting device propped at designated places or at
appropriate places.
When adjusting, cleaning, maintaining and repairing the machine, secure those parts of the machine that could
put the operator in danger by fall or other movement.
