Farm King 1460, Operator And Parts Manual, Page: 37 / 168

Assembly - Fertilizer Applicator 1460
37
John Blue Ground Driven Pump Installation Move the fertilizer applicator and John Blue Ground
Driven Pump to a flat level area with access to
compressed air and a hoist or forklift access.
Stop the tractor and engage the park brake.
Fully raise the toolbar, stop the engine and leave the
operator’s position. (See “Leaving The Operator’s
Position” on page 45.)
Place chock blocks in front and behind the tractor tires to
prevent tractor and fertilizer applicator from moving
during installation.
Fully raise the jack.
Figure 15
Remove the four 5/8” bolts / lock nuts (Item 1) and the
two backing plates (Item 2)
[Figure 15] from the pump
assembly.
• DO NOT permit bystanders to be in the work area
when unloading and assembling the fertilizer
applicator components.
• DO NOT work under suspended parts.
• Keep away from moving parts.
• Always use lifting devices / vehicles, chains or
straps of adequate size and strength when
unloading and assembling the fertilizer
applicator components.
AVOID INJURY OR DEATH
Keep fingers and hands out of pinch points when
assembling the equipment.
An approved lifting device and compressed air are
required when installing the ground driven pump.
B-11049
1
2
Always use chains, straps and lifting devices that
are in good condition and of adequate size to lift the
fertilizer applicator components.