1450H Bale Carrier
3
Optional Bale Stop (815692)
When loading narrower bales (4’), an adjustable
bale stop is available. Using this stop permits
loading bales closer to the front of the bale carrier
so a full complement of 10 bales can be loaded.
This stop is bolted to the lift arm with supplied
U-Bolts and is adjusted to the position desired.
Bale Pusher Operation
CAUTION
To avoid unbalanced loads the operator is only
required to push back one bale length to prepare
for the next bale.
NOTE: Lower loading arm before operating the
pusher.
Act on the hydraulic controls to move the bales
far enough to the rear to provide room to load the
next bale.
Return pusher all the way to the front by acting
on the hydraulic controls.
Rotating Pickup Arm (RPU)
The rotating pick up arm (RPU) loads bales “side
on”. The lift arm starts in the lowered position.
Drive forward until the forks are positioned around
the ends of the bale with the inside stationary fork
as close as possible to the bale.
Act on the hydraulic controls. The bale is then
squeezed on end until the pressure matches the
sequence valve setting that rotates and raises the
bale.
When the bale is lifted above, the bale is released
by acting on the hydraulic controls. This releases
the bale and returns the RPU to the ready state for
the next bale. Refer to the assembly instructions
for adjusting RPU settings.
ROTATING PICKUP ARM