USE AND MAINTENANCE MANUAL - SECTION 4
AERIAL PLATFORM ELEVAH 70 - Rev. 04_2020
Page 4-1
SECTION 4. CONTROLS, LIGHTS AND MACHINE OPERATION
INTRODUCTION
ATTENTION
THE MANUFACTURER DOES NOT HAVE ANY DIRECT CONTROL OVER MACHINE
APPLICATION AND OPERATION. THE USER AND THE OPERATOR ARE REQUIRED TO
OBSERVE THE CORRECT SAFETY PROCEDURES.
The ELEVAH 70 model lifting appliances are electric machines provided with an aerial work platform,
assembled on a lifting mechanism with aluminium upright.
the lifting device is
INTENDED TO MOVE PERSONS TO THEIR WORK POSITIONS, FROM
WHERE THEY CAN CARRY OUT THEIR TASKS FROM THE WORK PLATFORM.
The main control station is located on the work platform. The operator can lift and lower the work
platform from the work platform control console (the machine is not equipped with self-propelling,
therefore shifting is by manual pushing, allowed only when the work platform is at the lowest
position). If the operator on the platform is unable to lower it, use the ground control station's
commands when servicing the machine or in an emergency. Vibrations generated by machines do
not constitute any danger for the operator who is on the work platform. The level of continuous sound
pressure (A measurement) on the work platform is less than 70 db (A).
MACHINE OPERATION
Preliminary operations
It is necessary for the following control conditions to be satisfied before activating the machine from
the work platform controls.
The voltage of the batteries, if present, must be sufficient enough to activate the machine (for
220 V external power, the plug must be connected to the electrical system).
The main power switch on the ground control station must be switched on.
Both emergency stop switches, one located on the ground control station and the other on
the control console of the work platform, must be in RESTORE position.
