FAR VT30IX-17 CI, Manual

Page: 32 / 70

ENGLISH
3
A. Take out the plastic tube (7) recovering the motor shaft. Loosen the nut (3) by turning it
anti-clockwise and take it out. Unscrew the 4 screws (4) located on the plate circling the
motor shaft.
B. Take the back grid by using its handle (5b), insert the grid by centering the motor shaft
into the center of the grid’s hole. Ensure to align the screw holes on the grid and on the motor
head.
C. Insert the 4 screws into the 4 holes and tighten until its blocking point. Ensure that the
back grid is well fixed by turning it smoothly on the right and on the left, it shall not move.
At the end of this assembling step, check that the fan handle is vertically aligned to the tube.
Follow below instructions to continue assembling:
A. Loosen the screw (3) located on the back of the fan black, turn it antil you cannot see its
bottom inside the tube’s hole. Insert the fan blade (2) on the motor shaft until its position.
B. Tighten the screw (3) onto the motor shaft until its blocking point as shown on the picture.
Turn manually the fan blade on the right and on the left to ensure the good assembling.