Fanvil Technology Co. Ltd
Addr:10/F Block A, Dualshine Global Science Innovation Center, Honglang North 2nd Road, Bao'an District, Shenzhen, China
Tel: +86-755-2640-2199 Email: [email protected] [email protected] Official Web:www.fanvil.com
2.
How to change network mode for PA2
There are three ways to change network mode for PA2, via "volume up" button, via DSS key and
via web page management system. Please check the following steps for detail. The default network
mode for PA2 is Static IP mode with default IP address 192.168.1.128. If the network mode of PA2
is Static IP, you can change it to DHCP. If the network mode of PA2 is DHCP, you can change it to
Static IP with IP address 192.168.1.128.
2.1.
Change network mode for PA2 via "volume up" button
Step1.
Refer to the above connection diagram, connect speaker to PA2 and connect PA2 to PoE switch.
Step2.
After PA2 finishes booting and gets into standby mode:
Long press its "volume up" button for 10 seconds, the beep sound will ring out and last for 5
seconds. Press the "Volume up" button three times continuously during the 5 seconds to change
the network mode. After it had network mode changed successfully, the device will broadcast its
IP address later.
2.2.
Change network mode for PA2 via DSS key
Step1.
Refer to the above connection diagram, connect speaker and button to PA2, connect PA2 to PoE
switch. The button will work as DSS key.
Step2.
After PA2 finishes booting and gets into standby mode:
Long press its DSS key for 10 seconds, the beep sound will ring out and last for 5 seconds. Press the
DSS key three times continuously during the 5 seconds to change the network mode. After it had
network mode changed successfully, the device broadcast its IP address later.
2.3.
Change network mode for PA2 via webpage
Step1.
Load the web page management system of PA2.
Step2.
Go to web page “Network” -> “Basic”, set the network mode as you need, and then click “Apply”
button to save your changes.