Step 4: Install the wall bracket, wiring and casing
A. Align the screw holes of the wall bracket with the drilled holes on the wall, put in the
ijPPUXEEHUSOXJDQGIL[LWRQWKHZDOOZLWKWKH7$PPVFUHZVSURYLGHG
as shown in Figure 3-4.
B. Pass all the wires through the silicone plug in the middle of the bottom case, and
reserve a length of 15~20CM for all wires, as shown in Figure 3-5.
Note: The outlet hole of the bottom case faces down.
Figure 3-4
Figure 3-5
TA4*30mm
C. Connect the network cable with the RJ45 crystal head, and connect the power cable
and the terminals of the electric lock control cable. Please refer to Section 2 for the
connection sequence.
D. Connect the connected terminals to the motherboard socket, see Section 2 for the
connection location.
Figure 3-6
Flush mounting:
Step 1: Installation preparation
A.Check the following contents:
Built-in wall box x1
Built-in wall decorative panel x1
Built-in wall bracket x2
KM3*6mm screw x3
PM3*3mm screw x5
PM3*4mm screw x5
ijPPVFUHZDQFKRU[
M3*70mm screwdriver x1
E. Test whether there is electricity by doing the following:
Enter the dialing interface, enter #*107, enter the password, enter the engineering
mode, you can view the IP address of the device, and you can switch between static
and dynamic IP modes.
Enter the local opening password or test the indoor opening to see if the electric lock
works normally.
If it works fine, continue with the next steps.
F. Fasten the device and the wall bracket from top to bottom, and tighten the screws at
the bottom, as shown in the figure 3-6.
