TOOLS & SUPPLIES REQUIRED FOR EASY INSTALLATION
• 3/32 Hex Wrench
• 5/64 Hex Wrench
• 1.5mm Hex Wrench
• 2.5mm Hex Wrench
• 5/16 Nut Driver
• 5.5mm Nut Driver
• Needle Nose Pliers
• Piston Stop (Clutch Tool)
• Phillips Screwdriver
• Flat Blade Screwdriver
• Hobby Knife
• Thread Lock
• New Fuel Line
• Filter Oil
• After-Run Oil
• Throttle Return Spring
• Air Filter
• Manifold
• Small Nylon Tie Straps (air filter)
• Large Nylon Tie Straps (manifold)
• Pipe Wire Mount
REMOVING THE OLD ENGINE (If Applicable)
1.
If your new Fantom engine is replacing an existing engine, you will need to remove your old engine from the vehicle, following
your vehicle’s instruction manual. If this is a new installation, please refer to this manual for installation instructions. You
may also want to refer to your vehicle’s instruction manual for any special instructions not covered in this manual.
2.
If applicable, remove your old engine from the original engine mount and set it aside to use with your new Fantom engine.
3.
If applicable, disassemble the stock clutch parts from your original engine, noting the order of their removal, as you will need
to install them on your new Fantom engine in the exact reverse order that you removed them from your original engine.
Clutch removal and installation is best accomplished by using a clutch tool (piston stop tool); this can be obtained at a quality
hobby shop. This tool allows you to fully tighten or loosen the clutch nut by keeping the piston from moving up and down or
allowing the crankshaft to turn. Never wedge anything inside your engine’s exhaust or attempt to grip the shaft with pliers
as these techniques will permanently damage internal and external parts.
2
269. 649. 9583
