Operating Your Wet/Dry Vacuum
Warning
: To reduce the risk of fire or explosion,
do
not
operate this unit in areas with flammable gases,
vapors or explosive dust in the air. Flammable gases or
vapors include but are not limited to: lighter fluid,
solvent type cleaners, oil base paints, gasoline, alcohol
or aerosol sprays. Explosive dusts include but are not
limited to; coal, magnesium, grain or gun powder.
Do
not
vacuum explosive dust, flammable or combustible
liquids or hot ashes. To reduce the risk of health
hazards from vapors or dusts,
do not
vacuum toxic
materials.
Attachments
Floor to Carpet Brush
– Used for
dry pick-up. To use for carpets
press toggle switch down to the
front of the brush to raise the bristles;
to switch to bare floor setting
press the toggle switch to the
back of the brush to lower the bristles.
Crevice Tool
– Use for wet or dry
pick-up in tight corners, good for
automobiles etc.
Squeegee
- Use for wet pick-up
on flat surfaces to pick up liquids
and dry the surface quicker.
Extension Tubes
– For an extended
reach insert one or two of the extension
tubes onto the flexible hose. Slide one
tube into the other, then slide the
extension tube assembly into
the handle end of the flexible hose.
Attachments slide easily onto the handle end of the
flexible hose or the extension tubes.
OPERATING INSTRUCTIONS
Assemble the Hose
1.
Insert the wide end of the hose into the hose
intake. (Fig. 17)
2.
Attach one of the extension tubes onto the handle
part of the flexible hose. (Fig. 18)
Fig. 15
Locking
Clasp
For Wet Pick-Up
Warning
:
To reduce risk of electric shock -
unplug before cleaning, assembly or emptying
canister.
1.
To assemble the filter for wet pick
up, turn the filter holder upside
down on a level surface. (Fig. 12)
2.
Remove the dust bag and filter
cartridge from the filter holder.
3.
Place the foam filter over the
filter holder. (Fig. 16)
Important
: Do not use the filter
cartridge or the dust bag for wet
pick-up.
4.
Ensure that the foam filter is all the way down on
the filter holder.
5.
Follow the instructions from the “For Dry Pick-Up”
section to assemble the filter holder onto the
canister.
Warning
:
If water is seen to be coming from the
exhaust - immediately turn the unit off and unplug from
electrical outlet. Empty canister and clean.
Important:
This unit is supplied with a safety feature
that will stop air flow if the tank is overfilled or tips
over. If the airflow is stopped, turn the vacuum off,
empty the canister, then reassemble the vacuum and
continue vacuuming.
3.
For a longer reach you can attach the other
extension tube to the first one.
4.
Attach the desired attachment for the task onto the
end of the extension tube or directly onto the
handle of the flexible hose. (Fig. 19)
Fig. 17
Fig. 19
Toggle Switch
Fig. 16
5
Fig. 14
3.
Place the dust bag onto the
filter cartridge, ensuring that
the elastic at the bottom of
the bag is at the bottom
of the filter. (Fig. 14)
4.
Turn the filter holder over
and place in the vacuum
canister with the power
cord in the rear.
Warning
: Grasp the power
cord and hose storage on the filter holder to place the
assembly into the canister, as cuts may occur from
edge of filter holder.
5.
Secure the filter
holder with the
three (3) locking
clasps. (Fig. 12)
Fig. 18
Summary of Contents for CW233H
Page 2: ......