21
FANTEC DS-X2U3-Glanz DOCKING STATION
7) u
SIng
thE
dEvIcE
for
clonIng
Important notE:
When cloning, make sure that the source drive is inserted in the front
HDD A slot and the destination drive is inserted in the rear HDD B slot.
The destination drive must have an actual capacity greater than or
equal to the byte of the source drive.
1. Connect the power supply to the docking station and to a
power outlet.
2. Make sure the USB port is not connected.
3. Insert your source drive into the front slot „HDD A“ and the target
drive in the rear slot „HDD B“.
4. Switch on the device with the main switch on the back
[the POWER LED and the two status LEDs „HDD A“ +
„HDD B“ light up].
5. Press and hold the clone button for 5 seconds to complete the
process to start.
6. The top four colored LEDs move back and forth. After this the first
25% have been cloned, the first LED remains permanent switched
on and the rest of them continue to wander back and forth.
At 50% the next LED stays on permanently. If all LEDs stay on
permanently, the cloning process is complete.
