Fantasea Nano Ray Lighting Sets Instruction Manual 27110120
5
4.
XL Stay Slot Tray Special Instructions
a.
Mounting the Camera Housing on the XL Stay Slot Tray-
i.
Hold the camera housing above the tray in a way that the lip of the tray is
positioned at the back of the camera housing and the mounting screw hole
at the bottom of the camera housing is aligned with the mounting screw
hole featured on the tray.
ii.
Tighten the tray mounting screw to the camera housing mounting screw
hole, while making sure that there is a reasonable friction between the back
lip of the tray and the back side of the camera housing, so that it assists with
stabilizing the camera housing on the tray.
iii.
Once the screw was tightened, make sure that the camera housing is stable
on the tray by gently rotating it from side to side. If the camera housing is
not stable, repeat steps 1-2, making sure that there is a reasonable friction
between the back lip of the tray and the back side of the camera housing, so
it assists with stabilizing the camera housing.
b.
Mounting the Flex Arm on the XL Stay Slot Tray-
Follow the Flex Arm instruction manual in order to mount the Flex Arm on the XL
Stay Slot Tray.
5.
Care & Maintenance
The Nano Ray Set requires only a minimum amount of care for reliable
performance. The following tips will enable you to get the best results:
a.
Submerge all components in fresh water for about 20 minutes after every dive in
order to dissolve salt water crystals. Manipulate each of the movable controls to
assist the removal of salt particles from these tight areas.
b.
Allow the components to dry thoroughly before packing them away for the day
or for the trip home. You may use a soft towel or cloth to dry the components. Be
sure there is no grease or other debris on the towel.
c.
Visually check the condition of the Nano Flash and Nano Focus Light O-rings
before every dive. If they are dirty, clean them with fresh water and dry them
with a soft cloth as described above. If they are damaged in any way, such as cut
or perforated, replace them immediately.
d.
It is recommended to slightly lubricate radial O-rings periodically. It's important
to note that the amount of lubrication required on the O-ring is only enough to
allow it to slip into place without friction, so it does not twist or become
dislodged. More grease is not better, and could in some cases interfere with the
watertight seal of the product.
e.
Do not drop the lighting set on hard surfaces. It is not a shock absorber, and
could crack, affecting the watertight integrity of some components. It could also
cause damage to the electronic components inside the Nano Flash and Nano
Focus Light.
