Fantasea Nano Fiber Instruction Manual Download Page 3

 

3

 

Fantasea Nano Fiber Optic Cable Kit Instruction Manual 20110120

 

b.

 

The other end of the fiber optic cable attaches outside of the camera 
housing - opposite the camera internal flash - by using both sides of the 
Velcro strip included in the kit. The white plastic fitting normally comes with 
the Velcro tape attached and therefore you are only required to apply the 
other side of the Velcro strip on the housing to receive it (figures C and D). If 
your housing features a built-in flash diffuser, the Velcro strip should be 
attached beneath it, directly to the housing. If possible, place the Velcro 
strip between the built in flash diffuser and the housing, positioned opposite 
the internal flash of the camera. 
 
 
 
 
 
 
 
 
 

 

 

c.

 

It is preferable to totally block out the internal flash of the camera after 
attaching the camera side of the cable by applying black electrical tape over 
the fiber optic connector attached to the housing case. This effectively 
achieves two things: it diminishes the effects of backscatter, as well as 
eliminates any shadowing effect caused by lens accessories mounted on the 
housing lens port. Removing the built-in flash diffuser will have no affect on 
lighting. 

 

d.

 

Follow the instructions on your strobe manual in order to synchronize your 
camera with the external strobe. Please note that each digital camera 
features a different number of pre-flashes, which requires the strobe pre-
flash mode to be selected accordingly. It is recommended to test the 
synchronization when photographing opposite a mirror. In this case, the 
output of both flash units (the camera and the slave) should be visible in the 
test shot taken. 

 

3.

 

Care & Maintenance  

a.

 

After each dive, carefully soak and rinse exterior components in fresh water.

 

b.

 

Store the Nano Fiber Optic Cable in a protected, dry and shaded area.

 

c.

 

In some cases, after using the fiber optic cable frequently or for a long 
period, you might encounter a decrease in performance. You can easily solve 
this problem by cutting 1 cm/0.3 inch off the fiber optic cable ends, using a 

Figure C

 

 

 

 

Figure D

 

 

Summary of Contents for Nano Fiber

Page 1: ...era are positioned on the same axis and as long as there is not much ambient light available However if the strobe slave sensor isn t pointed directly at the camera internal flash or when photographing during daylight in clear water and bright conditions the slave sensor might fail recognizing the output of the camera internal flash Connecting the Nano Fiber Optic Cable between the camera internal...

Page 2: ...the fiber optic cable c Carefully but firmly insert the black adaptor inside the proper fitting in front of the strobe s slave sensor If attaching the fiber optic cable to the Fantasea Nano Flash Cat No 6115 install the black and clear plastic diffuser cover on the Nano Flash Housing if it isn t already assembled Insert the black adaptor inside the lower right grommet the one with the wider hole o...

Page 3: ... This effectively achieves two things it diminishes the effects of backscatter as well as eliminates any shadowing effect caused by lens accessories mounted on the housing lens port Removing the built in flash diffuser will have no affect on lighting d Follow the instructions on your strobe manual in order to synchronize your camera with the external strobe Please note that each digital camera fea...

Page 4: ...h the purchase was made as you may be required to show proof of purchase if you need warranty service The following conditions apply 1 This warranty extends to the original purchaser only It is not assignable or transferable 2 The warranty does not cover damage resulting from misuse abuse negligence or accidents Proper maintenance of the Product is the responsibility of the owner 3 The warranty do...

Reviews: