2
EyeDaptor G9-G10 Instruction Manual
4.
Insert the
EyeDaptor G9-G10
into the dedicated groove of the
BigEye Lens G10
.
Note that the two screw holes on the
EyeDaptor G9-G10
wings should be perfectly
aligned with the two small screw holes on the
BigEye Lens G10.
5.
Insert the screws included into the dedicated screw holes on the two adaptor wings
and use the screwdriver included to tighten the screws into the adaptor and the
BigEye Lens G10
(see image #2 on the following page). Tighten the screws enough in
order to keep the
EyeDaptor G9-G10
fixed inside the
BigEye Lens G10
, but don’t
tighten it too strongly, as this might cause damage to the products.
6.
During the dive, install the
BigEye Lens G10
with the adaptor inside by attaching the
accessory lens to the housing lens port, as described on the
BigEye Lens G10
instruction manual.
7.
When removing the
BigEye Lens G10
from the housing with the adaptor installed
inside, it can be conveniently stored by attaching it to the
EyeGrabber G7/G9
(Cat.
No. 4055), which mounts on Fantasea Flex Arms, thereby making it easily available
for future use. For further information, please visit our website at
www.fantasea.com/FantaseaEyes
8.
After the dive, detach the accessory lens from the housing lens port, including all
adaptors, and rinse all lens components in fresh water.
9.
Dry and store in a safe protected place.
Image #1:
Hold the EyeDaptor G9-G10 so the
wings are on the top side of it
Image #2:
Tightening the screws on the two
EyeDaptor G9-G10 wings (adaptor is highlighted)
