Page 5
_ _ _
ENTER AREA CODE
7 DIGITS DIAL
3 0 3
ENTER AREA CODE
7 DIGITS DIAL
_ _ _ - _ _ _ - _ _ _
ENTER AREA CODE
10 DIGITS DIAL
7 2 0
ENTER AREA CODE
10 DIGITS DIAL
Then, press the
Dial
button to confirm the selection.
5. Program your area code
(A) After selecting the language, the display flashes
"
ENTER AREA
CODE
" and “
7 DIGITS DIAL
”.
(B) If you dial your local calls using 7 digits (e.g., 555-
1212), then enter your local area code, press the
Dial
button, and go to Step C.
If you dial your local calls using 10 digits (e.g., 303-
555-1212), then enter “000” as the area code for 7
digits dial, and press the
Dial
button to go to Step C.
(C) The display flashes “
ENTER AREA CODE
” and “
10
DIGITS DIAL
”.
Enter the area code(s) for numbers that you dial
using ten digits (e.g., 720-555-1234). You can store
up to three area codes for ten-digit dialing. Press
Dial
when you are done. If there is no number you
dial using ten digits, then press
Dial
.
6. Press
the
Save
button to save these operating settings
and to exit the menu mode.
7. After installation, lift the telephone's
Handset
and listen for the dial tone. If there is no
dial tone, check to make sure all cords are firmly plugged into their jacks.
Note: Programming your area code will allow you to easily dial numbers that are in your
Caller ID list. See the Section “
Calling Back a Number from the Caller ID List”
for more
information on dialing calls from your Caller ID list.
Wall Mounting
To mount the telephone on the wall, you must reverse the
Handset Tab
on the base of the
phone and attach the
Wall Mount Bracket
to the bottom of the phone.
1. Remove the
Handset
from the
Handset Cradle
and slide the plastic
Handset Tab
(located just below the
Hook Switch
) up and out of its slot.
2. Turn the
Handset Tab
around and reinsert the tab back into its slot so that the plastic
tab extends outward acting as a hook to hold the
Handset
when mounted on the wall.
3. Turn the phone over so that you are looking at the bottom of the phone. Insert tabs at
the thin end of the wall mount bracket into the holes at the rear of the phone bottom.
Press and latch the tabs at the thicker end of the wall
bracket into holes at the front end of phone. The back of
