Fanimation Zonix FP4620 Series, Owner'S Manual, Page: 7 / 14

WH-T
O MOT
OR
BLK-T
O MOT
OR
BLU-T
O LIGHT
TO HOT
BLK
TO FAN
GRN
TO GROUND
BLK
GRN
WH
BLK
120 VAC SUPPLY
(User Supplied)
GRN from hanger ball GRN from bracket
7
How to Wire Your Ceiling Fan - CW40 Wall Control
If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a
licensed electrician.
ʆ WARNING
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
Installing the Canopy Housing
Figure 1a Figure 1b
NOTE: This step is applicable after the necessary wiring
is completed.
ʆ WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy housing
and not pinched between the housing and the ceiling.
1. Loosen the two shoulder screws in the Hanger
Bracket.
2. Securely attach the Canopy Housing over the shoulder
screws (Figure 1a).
3. Securely attach and tighten the Canopy Screw Cover
over the shoulder screws in the Hanger Bracket utilizing
the keyslot twist-lock feature (Figure 1b).
Figure 1
Figure 2
Hot Supply
Ground
Supply To Fan
ʆ WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan until the blades are in place. Noise and fan damage
could result.
1. Installing Wall Control (Figures 1 & 2):
• With electrical power still disconnected, remove the
existing wall plate and switch.
• Make wiring connections with wire nuts as shown in
Figure 1.
– One black wire from wall control unit to black
(hot supply).
– One black wire from wall control unit to black wire
leading to ceiling outlet box.
– One green wire from wall control unit to ground wire
leading to ceiling outlet box.
• Attach wall control unit to outlet box using the two
6-32 screws provided.
• Attach wall plate to the switch control front using the two
small screws provided.
NOTE: Blue wire MUST be capped if not installing optional light
kit.