11
Housing Switch Cup / Adapter Plate Assembly
Figure 2
Figure 1b
Figure 1a
Housing Switch Cup/Adapter Assembly:
1.
Disassemble the Housing Switch Cup/Adapter assembly
by removing three screws. (Figure 1a)
2.
Loosen two screws and remove one screw from Housing
Support Bracket.
3.
Assemble the Adapter Plate assembly on the Housing
Support Bracket by rotating plate and properly positioning
screws in key slots. Install third screw in remaining hole.
Fully tighten all three screws. (Figure 1b)
4.
Securely attach the 9-pin Switch Cup connector to wiring
harness socket within Adapter Plate assembly.
(Figure 1b)
5.
Assemble the Housing Switch Cup onto the assembled
Adapter Plate with three screws. (Figure 2)
6.
Repeat above steps for the second motor assembly.
INSTALLATION NOTE
This section is applicable after the fan and the blades are
completely installed.
1.
Blade holders come packed in two different bundles, one
blade holder set is marked with a red dot (5 pcs) and one
blade holder set is marked with white dot (5 pcs). These
colored dots indicate which motor switch set-up (red or
white dot) to attach these blade holders to.
2.
Using the (blade holder to hub) screws with lockwashers
attach the blade holders to the corresponding motor
assembly which also will be switched with a white or a red
dot.
NOTE: Assemble with Hand Tools Only!
3.
Make sure the screws securing the blade holders to
the hub are secure not over-tightened and that the blade
holders are properly seated on the hub (Figure 1).
Blade Attachment
Blade Holder
Screw w/lockwasher
(2 per blade holder)
Figure 1
INSTALLATION NOTE
Attach the fan blades after hanging the fan body and
wiring the fan to prevent blade breakage or damage.
INSTALLATION NOTE
Blade pitch is very important in the operation of your
fan. Use blade holders and blade sets designed for the
Caruso fan only.