11
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
CAUTION
1.
Position the blade over the blade holder with
threaded posts showing. Make sure the bottom
edge of the blade is fully seated against the blade
arm. With a phillips screwdriver, tighten
3/16-24 x 8 mm washer head screws and fiber
washers to secure the blade to the blade arm.
(Figure 18)
2.
Remove and discard the motor stops from the
motor assembly by removing the screws.
(Figure 19)
x 15
x 15
FIBER WASHER
3/16-24x8 mm
WASHER HEAD
SCREWS
HARDWARE USED:
Blade Holder Arm
Motor
Motor
Stops
Assembly
Blade
Figure 18
Figure 19
Assembling and Mounting the Fan Blades
3.
Secure the blade holders to the motor support
using the 1/4-20 x 14 mm screws through the holes
located on the side of the motor support (Figure 20).
NOTE:
Periodically check blade holder hardware and
resecure if necessary.
x 10
1/4-20x14 mm
Pan Head Screw
HARDWARE USED:
Figure 20
To reduce the risk of personal injury, do not bend the
blade holders when installing, balancing the blades or
cleaning the fan. Do not insert foreign objects in
between the rotating blades.
▲
WARNING
Pan Head Screw
(2 per blade holder)
