Fanimation Michael David's Adventure LB1820BL, Owner'S Manual

Page: 3 / 16

3
This Manual is Designed to Make it as Easy as Possible for You
to Assemble, Install, Operate, and Maintain Your Ceiling Fan
Unpacking Instructions
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
steps have been completed and will be helpful in
fi nding your place should you be interrupted.
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are missing,
contact your local retailer.
Tools Needed for Assembly Materials
•
One Phillips head screwdriver
•
One stepladder
•
One 1/4” blade screwdriver
•
One wire stripper
•
Three wire connectors
(supplied)
Wire Size A.W.G. Installed Wire Length
14
12
Up to 50 ft.
50 - 100 ft.
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration. (Figure 1, page 13)
Hanger Bracket
Assembly
Fan Motor
Assembly
Hardware Bag
Ceiling Canopy
Remote Module
Unit
C23 Wall
Control
C22 Remote
Control
Wood
Blade Holders
(Set of 4)
Cover Switch Housing
Downrod/
Hanger Ball
▲ WARNING
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
your retail store for missing or damaged parts.
▲ WARNING
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 4). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
Light Fitter
Beaded Shade (4)
Downrod Sleeve
Blade Set
• Fan Motor assembly
• Hanger Bracket
• Ceiling Canopy
• Downrod/Hanger Ball assembly
• Downrod Fabric Sleeve
• Four Wood Blade Holders
• Four Wood Blades
• C22 Remote Control
• C23 Wall Control
• Receiver Module Unit
• Light Fitter
– Lauren Brooks pull chain
• Four Beaded Shades
• Support Cable Bag
– Ceiling Support Cable
– Cable Clamp
– 2 ˝ Lag Bolt
– Flat Washer
• Hardware bag:
– Nine 10-32 x ½ ˝
(blade holder to fan
motor assembly) screws
– Two 5/32 ˝ threaded rods
– Two 5/32 ˝ lockwashers
– Two knurled knobs
– Two Cover Hsg screws
– Three wire connectors
• Blade Mounting Hardware Bag
– Thirteen wood blade screws
– Thirteen wood blade flat
washers
– Fanimation screwdriver
– Angled screwdriver