Fanimation Louvre FP1320 Series, Owner'S Manual

Page: 4 / 16

3. Optional fan only wall slide control (C1), see page 9.
4. Optional fan & light slide wall control (C2) or optional
2-fan slide wall control (C5). Please see instructions
provided with control.
4
Electrical and Structural Requirements
Wiring and Control Options
Please choose one of the following options and proceed to
the page as indicated.
1. Standard 4-position, 3-speed, pull chain switch and
reverse slide switch, see page 7.
2. Optional fan & light remote control (C4), see page 8.
NOTE: If you are using a Fanimation Light Fixture with
your fan, see Ceiling Fan Light Kit Installation Instructions
(packed with light kit) for wiring.
DAMP LOCATION CEILING FAN: If you have purchased
a Damp Location Ceiling Fan, you may only use light kits
marked suitable for use in damp locations.
Your new ceiling fan will require a grounded electrical
supply line of 120 volts AC, 60 Hz, 15 amp circuit. The
outlet box must be securely anchored and capable of
withstanding a load of at least 50 lbs. Figure 1 depicts
different structural configurations that may be used for
mounting the outlet box.
If your fan is to replace an existing light fixture, turn
electricity off at the main fuse box at this time and remove
the existing light fixture.
Ceiling
Ceiling
Joists
2 ˝ x 4 ˝
Outlet
Box
Figure 1
How to Assemble Your Ceiling Fan
Pin
Setscrew
Hanger
Ball
Figure 2
1. Prior to assembly, set aside and save the hardware
bag(s) packed in the packing.
2. Remove the Hanger Ball by loosening the setscrew
in the Hanger Ball until the ball falls freely down the
Downrod. (Figure 2) Remove the Pin from the Downrod,
then remove the Hanger Ball. Retain the Pin and Hanger
Ball for reinstallation in Step 6.
3. The fan comes with blue, black, and white 80 ˝ wires.
Separate and untwist the three wires. Route the wires
through the Downrod.
▲ WARNING
To avoid fire or shock, follow all wiring instructions
carefully. Any electrical work not described in these
instructions should be done or approved by a licensed
electrician.
▲ WARNING
Turning off wall switch is not sufficent. To avoid
possible electrical shock, be sure electricity is turned
off at the main fuse box before wiring. All wiring must
be in accordance with National and Local codes and the
ceiling fan must be properly grounded as a precaution
against possible electrical shock.
▲ WARNING
To reduce the risk of fire, electrical shock, or personal
injury, mount fan to outlet box marked acceptable for fan
support, and use screws supplied with outlet box. Most
outlet boxes commonly used for support of light fixtures
are not acceptable for fan support and may need to be
replaced. Consult a qualified electrician if in doubt.