Figure 1
7
How to Wire Your Ceiling Fan – Rotary Switch
How to Wire Your Ceiling Fan – CW110 Wall Control
If you feel that you do not have enough electrical wiring
knowledge or experience, have your fan installed by a
licensed electrician.
NOTE:
If fan or supply wires are different colors than indicated,
have this unit installed by a quali
fi
ed electrician.
▲
WARNING
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
1.
Run the black, white and green wires through the
wiring hole in the side of the hanger bracket to allow for
electrical connections.
2.
Connect the green grounding wire from the fan and
hanger bracket to the grounding wire from the outlet box
(this may be a bare wire or a wire with green insulation).
Securely connect these wires with wire connector
supplied with your fan.
3.
Securely connect the white wire from the fan motor
to the white supply (neutral) wire using wire connector
supplied (Figure 1).
4.
Securely connect the black fan motor wire to the black
supply wire using wire connector supplied (Figure 1).
5.
After connections have been made, turn leads upward
and carefully push leads into the outlet box, with the white
and green leads to one side of the box and the black
leads towards the other side.
120 VAC
Supply
(User
Supplied)
Black Wire (Hot)
White
(Neutral)
Green Wire
(Ground)
(To/From
hanger
bracket
and fan)
WH-T
O MOT
OR
BLK-T
O MOT
OR
TO HOT
BLK
TO FAN
GRN
TO GROUND
BLK
GRN
WH
BLK
120 VAC SUPPLY
(User Supplied)
GRN from hanger ball
GRN from bracket
If you feel that you do not have enough electrical wiring knowledge or experience, have your fan installed by a
licensed electrician.
▲
WARNING
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
Figure 1
1.
Installing Wall Control (Figures 1 & 2):
• With electrical power still disconnected, remove the
existing wall plate and switch.
• Make wiring connections with wire nuts as shown in
Figure 1.
– One black wire from wall control unit to black
(hot supply).
– One black wire from wall control unit to black wire
leading to ceiling outlet box.
– One green wire from wall control unit to ground wire
leading to ceiling outlet box.
