8
How to Assemble Your Ceiling Fan (Continued)
7.
Reinstall the hanger ball on the downrod as follows.
Route the wires through the hanger ball. Position the
pin through the two holes in the downrod and align
the hanger ball so the pin is captured in the groove in
the top of the hanger ball. Pull the hanger ball up tight
against the pin. Securely tighten the set screw in the
hanger ball. A loose set screw could create fan
wobble. (Figure 7)
Figure 8
8.
Remove one of the two shoulder screws in the
hanger bracket and retain the screw for later. Loosen
the second shoulder screw without fully removing it.
(Figure 8)
Hanger Bracket
Figure 7
CAUTION
All set screws must be checked, and retightened where
necessary before installation.
6.
Route wires through motor coupling cover, canopy
screw cover and ceiling canopy. (Figure 6)
Ceiling Canopy
Canopy Screw Cover
Motor Coupling
Cover
Figure 6
5.
Thread downrod into the downrod support on top of
the motor. Install the clevis pin by aligning the holes
in the downrod support with holes in the downrod.
Secure clevis pin with hairpin clip. Tighten the two set
screws with nuts in the downrod support. Securely
tighten the set screws with screwdriver then fully
tighten the nuts by hex wrench. (Figure 5)
Figure 5
WARNING
It is critical that the clevis pin in the downrod support
is properly installed and the set screws and nuts are
securely tightened. Failure to do so could result in the
fan falling.
Set Screws and
Locking Nuts (2)
Hairpin Clip
Downrod
Clevis Pin
