1.
IMPORTANT:
Using a full range dimmer switch
(not included) to control fan speed will damage the fan.
To reduce the risk of fire or electrical shock, do not use
a full range dimmer switch to control the fan speed.
(Figure 1)
2.
Restore electrical power to the outlet box by turning
the electricity on at the main fuse box. (Figure 2)
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not
operate fan until the blades are in place. Noise and
fan damage could result.
WARNING
WARNING
Do not operate this fan with a variable (Rheostat) wall
controller or dimmer switch. Doing so could result in
damage to the ceiling fan's remote control unit.
16
How to Operate Your Ceiling Fan (A1/C1)
MAIN FUSE BOX
Figure 2
Figure 1
For illustrative purposes only
-not
intended to cover all types of controls
: Turns off ceiling fan.
: Turns on ceiling fan to high speed
: Turns on ceiling fan to medium speed
: Turns on ceiling fan to low speed
NOTE: To use your smart device to control your
receiver, download the fanSync app from your app
store. Visit www.fanimation.com/fanSync
3.
Remote button functions are as follows: (Figure 3)
DOWN LIGHT ON/OFF: Press and release
button immediately to turn light on or off.
LIGHT DIMMER: Press and hold to dim or
brighten light to desired level and release.
Dimming feature is not available with certain bulbs,
i.e. CFLs
: Press and release immediately to set fan
direction in forward or reverse.
Figure 3
Figure 4
4.
Pairing Process for Receiver & Transmitter:
(Figure 4)
– The receiver and accompanying transmitter are
matched at the factory. If replacing transmitter or
receiver, you must follow the pairing process below
before using the unit. The fanSync receiver can be
paired to up to five (5) transmitters.
NOTE: Smart device pairing is unlimited.
– After installing the receiver unit, set desired
transmitter code by pushing dip switches (under
battery cover) up or down to the desired positions.
Once code is set, restore power to your fan and press
and hold the fan off button ( ) for approximately 1 to 3
seconds. Fan will turn off, then turn on to medium
speed to indicate that the pairing process is complete.
Please note that you must press the fan off button ( )
within 30 senconds after restoring power. Re-pairing
your device is not necessary after replacing the battery.
CR2430 3V
21',3
Dip Switch
Dimmer Switch
DIMMER
ON/OFF
NOTE:
Transmitters can pair to multiple receivers, when
performing the pairing process take care not to pair the
transmitter to unintended receivers. It is suggested that
fans more than seven feet apart be on separate power
switches.
Each fanSync receiver can pair to five different
transmitters (with different dip switch codes).
