3.
Once the connection has been made, slide the
receiver into the hanger bracket, taking care not to
pinch the wires. (Figure 4)
12
How to Wire Your Ceiling Fan (D1)
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before hanging
(Figure 1).
WARNING
MAIN FUSE BOX
Figure 1
NOTE:
If you are not sure if the outlet box is
grounded, contact a licensed electrician for advice, as
it must be grounded for safe operation.
Figure 2
1.
Connect the green grounding lead from the
downrod/hanger ball assembly and the green
grounding lead from the hanger bracket to the supply
grounding conductor (this may be a bare wire or wire
with green colored insulation). Securely connect wires
with wire connector. Securely connect the white fan
motor wire to the white supply (neutral) wire using
wire connector. Securely connect the black fan motor
wire to the black supply wire using wire connector
(Figure 2).
Green Wire
from Supply
(Ground)
White Wire
from Supply
White Wire
from Fan
Green Wire
from Hanger
Bracket (Ground)
Green Wire
from Fan (Ground)
Green Wire
from Hanger
Ball (Ground)
Listed
Outlet Box
Household
Supply
Black Wire
from Supply
Black Wire
from Fan
Green Wire
from Supply
(Ground)
White Wire
from Supply
White Wire
from Fan
Green Wire
from Hanger
Bracket (Ground)
Green Wire
from Fan (Ground)
Green Wire
from Hanger
Ball (Ground)
Listed
Outlet Box
Household
Supply
Black Wire
from Supply
Black Wire
from Fan
x 3
WIRE
CONNECTORS
HARDWARE USED:
NOTE:
If you feel that you do not have enough electrical
wiring knowledge or experience, have your fan installed
by a licensed electrician.
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors except for the ground wire. Do not
operate fan until the blades are in place. Noise and
motor damage could result.
WARNING
Figure 3
Figure 4
2.
After connections have been made, turn leads
upward and carefully push leads into the outlet
box, with the white and green leads to one side
of the box and the black leads toward the other side.
The wires should be spread apart with the grounded
conductor and the equipment-grounding conductor on
one side of the outlet box and the ungrounded conductor
on the other side of the outlet box. (Figure 3)
