Tab
10
Figure 2
Figure 1
Floor
No
less than
7 ft
How to Hang Your Ceiling Fan
ʆ
WARNING
The fan must be hung with at least 7´ of clearance from
floor to blades. (Figure 2)
ʆ
WARNING
The outlet box must be securely anchored and capable
of withstanding a load of at least 35 lbs. Hanger bracket
must seat firmly against outlet box. If the outlet box is
recessed, remove wallboard until bracket contacts box.
If bracket and/or outlet box are not securely attached,
the fan could wobble or fall.
ʆ
WARNING
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before hanging. (Figure 1)
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
1.
Securely attach the hanger bracket to the outlet box
using the outlet box screws and washers supplied with the
outlet box (Figure 3).
NOTE: Outlet box screws pass through slotted holes of
the hanger bracket (Figure 3).
2.
Pull the electric wires in the outlet box down through
the opening in the hanger bracket. If necessary, strip wire
ends. Bend wires up and out of the way.
Figure 3
Ceiling
Outlet Box
Hanger
Bracket
Tab
3A. For Downrod Fan
Carefully lift the fan and seat the downrod/hanger ball
assembly on the hanger bracket that was just attached to
the outlet box (Figure 4). Be sure the groove in the ball is
lined up with tab on the hanger bracket (Figure 3).
ʆ
WARNING
Failure to seat tab in groove could cause damage to
electrical wires and possible shock or fire hazard.
ʆ
WARNING
To avoid possible shock, do not pinch wires between the
downrod/hanger ball assembly and the hanger bracket.
3B. For Close-to-Ceiling Fan
Hook the motor assembly onto the ceiling bracket
assembly as shown. (Figure 5)
You can now proceed with the electrical wiring of your fan.
Screw (2)
Supplied with
Outlet Box
Outlet Box
Hanger
Bracket
Figure 4
Standard Hanger Ball
Sloped Hanger Ball
Hanger
Bracket
Ceiling Canopy
NOTE: MOTOR WIRES
HAVE BEEN OMITTED
FROM DIAGRAM
Hook
Figure 5
