17
8. INSTALL THE MOTOR BLOCK
Take the motor block and position it correctly in its mounting bracket. Help you with the small safety hook on
the mounting bracket.
Then tighten the 4 nuts and washers by using a suitable wrench. Make sure that you tighten the nuts properly
to prevent a fall.
Make the following electrical connections before installing the motor cover and blades :
1/ Connect all the ground wires together : the ground wire of the ceiling with the 2 ground wires of the motor
block and the one of the mounting ceiling support (yellow / green).
2/ Connect the ceiling neutral wire with the motor neutral wire (blue).
3/ Connect the ceiling phase wire with the motor phase wire (black) ; See section INSTALL THE WALL CON-
TROL.
4/ If you do not have the optional LED light kit, for safety isolate the light phase wire (red) in a separate domi-
no. If you have the LED light kit, connect the light phase wire (red) to a separate phase of your ceiling in order
to control the light by an independent switch. See section INSTALL THE LIGHT KIT (OPTIONAL).
CAUTION: Make sure that the wires are not in contact with the motor, the motor turning at high
speeds when the ceiling fan is in operation.
9. ELECTRICAL CONNECTIONS OF THE CEILING FAN
WARNING : Before proceeding to the electrical connections, carefully read the safety instructions in
this manual. Before any electrical connections, switch off all power and restart only when the instal-
lation is completed. Electrical connections must be made in accordance with current regulations and
by a qualified electrician.
10. INSTALL THE MOTOR COVER
Once the electrical connections have been made, install the motor cover.
Loosen 2 of the screws halfway and remove the other 2 from the mounting ceiling support. Position the motor
cover on the support by inserting the 2 screws, loosened halfway, in the notches of the motor cover, turn the
motor cover counterclockwise until the screws lock in the notches. Replace the 2 other screws then tighten
the 4 screws.
Summary of Contents for 52YFT-1021
Page 24: ...www fanelite com fanelitebrand...
