14
4. ASSEMBLY
WARNING : Before assembling your appliance, carefully read the safety instructions
in this manual.
1. Remove the rear grill locking ring from the motor by turning it counter-clockwise.
2. Place the rear grill onto the motor housing aligning the 3 raised knobs on the top of the
motor housing with the 3 holes on the rear grill and make sure the indents of the rear grill is
on the bottom.
3. Place the rear grill locking ring and tighten turning clockwise. Be sure to tighten the ring
correctly to secure the assembly of the rear grill and motor.
4. Align and place the blade onto the shaft of the motor until it locks in place. Then secure it
by tightening the blade locking nut counter-clockwise. Be sure to tighten the nut properly.
Check that the blade turns well by turning it manually.
5. Properly align the arrows on the top of the front grill with the rear grill. Push the front grill
clips into the rear grill until you hear a snap for each clip.
5. WALL MOUNTING
WARNING : Before installing your appliance, carefully read the safety instructions in
this manual. The fixing must be made securely in the wall structure by a qualified
person. We can not be held liable in the event of a fall of the appliance.
1. Locate and mark the position on the wall where the fan will be mounted (preferably at a
wall stud). The fan must be installed with a minimum distance of 230 cm between the floor
and blade.
2. Fix the wall bracket to the wall using the supplied screws and dowels. Leave
approximately
5/8” (1.6 cm) of the screws exposed.
3. Take the fan and install it on the wall bracket (wall bracket into the hole at the back of the
fan).
6. OPERATING INSTRUCTIONS
WARNING : Before using your appliance, carefully read the safety instructions in this
manual.
Plug in the power cord. Insert two batteries AAA into the remote control (see section
REPLACING THE BATTERIES
for more information).
Summary of Contents for 15833-R PG
Page 18: ...18 www fanelite com...