-3-
A
Photography lights will be installed in the camera or
photographic camera lights before removed, is required to set
the power switch in OFF.
Photography lights installed
1. Rotating photographic lights, make it with the consistent direction of the camera lens
2. Photography lights interface will be inserted into the interface of the camera
concave-shaped
3. Clockwise rotating locking until locked in place
Photographic lights removed
The opposite direction along the arrow anti-clockwise rotating locking to Release it
The opposite direction along pull out the photographic light, removed it
The use for photographic light
1. To following the picture to install the battery, when heard a weak "pyridaben
carbazole" sound the installation is completed.
2. When need to replace the battery push the battery lock in accordance with the
arrow direction to promote the battery can be unloaded.
3. When you turn on the photographic light please set the power switch to "ON"
4. When you turn off the photographic light please set the photographic light to "OFF
5. As following picture to push dimmer it will be adjust the illumination scope
6. Want Soft, you can use the equipment soft-film. soft-film can also working with the
Amber film in the same time.
7. According to filming luminous efficiency need to select color temperature, Without
the filter Color temperature is 5600K for daylight. Use the Amber film the luminous
efficiency color temperature is 3200K.
B
1. When the electric will run out of time, power will be cut off, after few seconds it will
re-open, it can still light up a few seconds,then will be cut off again. Please
replace the batteries at this time, to prevent influence onuse.
2. After use Please set the power switch to "OFF"
3. When not in use, please remove the battery and then bring photographic lights
stored in boxes.
4. In storage before, make sure photography lights are cool.
Note
