10
later, setting temperature will go down 1
℃
, the second one hour later , the setting
temperature will go down another 1
℃
, and then keep the same .
·
Sleeping mode is invalid under dehumidifying and fan mode. Under water full,
machine standby and mode conversion, sleeping mode will be cancelled .
Compressor protection
·
Three minutes later after power on / restart, compressor starts to run.
Water Drainage
This machine with auto-water-evaporating system. Condensed-water cycle to cool
down the condenser, which will not only improve cooling efficiency, but also save
energy.
·
If inner water tank is full, “W.F” indicator will flashed on the screen , machine enter into
standby mode, buzzer shouts , compressor stops and all keys is invalid till machine
recovers to be normal .
·
Pull out the plug to drain out water, power off the machine and restart it , the machine
will runs normally .
Special caution for heating mode !
When heating mode works, if don’t want to empty the water-tank under this mode,
please connect a water-drainage-pipe to remove the water out
continuously
.
1.
Remove the drain knob
2.
Remove the rubber plug and keep it for future use
3.
Fix the drain connector into the drain knob.
4.
Fix the drain knob to the water-outlet of the unit.
5.
Connect one end of the drain pipe (ID:10mm) into the water outlet as
following and put the other end into a water-container.
Note:
The water-container must be at or lower the outlet level.
