Fancyyyyy
10
Installation and
Calibration
Fig. 6: Rear of module
Power header with
red stripe down
Expander header 4
Expander headers
2&3.
Rung Divisions has four pin headers on the
rear of the module. Power should only be
connected to the pin header labelled
“POWER”. Connecting power to any of the
other pin headers could irreversibly damage
the module. The power header has reverse
power protection and should be installed
with the red stripe facing down aligned with
the mark on the rear PCB.
The trim-pot at the bottom of the module
sets the response of the Chance knob and
CV. All modules ship calibrated and should
not need recalibration. If for some reason
you wish to alter the response, send an audio
rate clock into Clock, monitor the 8-Bit
output, set chance to fully clockwise and
turn the trim-pot until the output pattern
does not change.
