IMPORTANT SAFEGUARDS:
Read all instructions carefully, even if you feel you are quite familiar with this type of appliance. When using
electrical appliances, in order to reduce the risk of fire, electric shock, and/or injury, these basic safety
precautions should always be followed:
1.
All wiring must be done by a licenced Electrician as on-site warranty may be voided if proof cannot be
provided. This ceiling fan
MUST
be installed by a Qualified Electrical Contractor in accordance with the
local regulations, and all local, state and national electrical codes. Any alterations or additions to building
wiring must be completed by a licensed electrical contractor, or person authorised by legislation to work
on the fixed wiring of any electrical installation.
2.
The fan must be connected to a 240V AC 50Hz power supply.
3.
All electrical work must only be undertaken after disconnection of the power by removing fuses or turning
off the circuit breaker, to ensure all pole isolation of the electrical supply.
4.
The fan must be earthed.
5.
The fan must be installed so that the blades are
at least
2.1 metres above the floor.
6.
The ceiling fan weight is 5.69 kg. The structure that the ceiling fan is mounted to must be capable of
supporting a weight of at least 45kg. The fixing must be able to support the moving weight of the fan and
must not twist or work loose.
7.
Make sure that the installation site will not allow the rotating fan blades to come into contact with any
object and that there is a minimum clearance of 150mm (6”) from the blade tip to the wall or ceiling.
Please note that the bigger this clearance is the better the airflow from your fan will be.
8.
DO NOT
install this product outdoors. Installing the fan in a position where it could be exposed to water,
moisture or external elements is dangerous.
9.
DO NOT
connect the fan motor to a dimmer switch. This may give an unsatisfactory
performance (motor
hum) and cause damage to the motor and/or controller. Use ONLY the provided remote control.
10.
This appliance is not intended for use by young children or infirm persons without supervision.
11.
Young children should be supervised to ensure that they
DO NOT
play with the appliance.
12.
It is
NOT
recommended that ceiling fans and gas appliances be operated in the same room at the same
time.
13.
The fan must be turned off and stopped completely before reversing the fan direction. This will prevent
any damage to the motor of the fan or controller.
14.
Do not insert anything into the fan blades whilst they are spinning. This will damage the blades and upset
the balance of the fan causing the unit to wobble.
15.
After the fan is completely installed make sure that all base and fan blade fixings are secured and
tightened to prevent any problems.
16.
Because of the fan’s natural movement, some connections may loosen. Check the support connections,
brackets and blade attachments twice a year to make sure they remain secured. If any are loose, tighten.
17.
If unusual oscillating movement is observed, immediately stop using the ceiling fan and contact the
manufacturer, its service agent or suitably qualified persons.
18.
The replacement of parts of the safety suspension system device shall be performed by the manufacturer,
its service agent or suitably qualified persons.
19.
If it is necessary to replace the live or neutral brushes to ensure operation of the motor then both brushes
and the earth brush shall be replaced at the same time. The brushes shall only be replaced by a suitably
qualified person.
20.
An all-pole disconnection incorporated in the fixed wiring is to be provided, such as an all-pole switch or a
supply cord fitted with a plug.
IMPORTANT NOTE:
The important safeguards and instructions given in this manual are not meant to cover all
possible conditions and situations that may occur. It must be understood that common sense,
caution and care are factors which cannot be built into any product.