6. Getting started
6.4 Fan control
The fan is controlled by temperature but for safety reason it is running at
maximum speed all the time by default. You can set the fan to be tempera-
ture controlled only by following these steps:
1. Enter stand-by mode. Tuning display shows “---“
2. Press the lower two
red buttons
and the buttons
“A”
and
“B”
at the same
time
In the Tuning display you first see the firmware version and then the
default status of the fan (“on” or “off”)
6.3 Calibration
A 6-speed gear stick (7GS) must be calibrated when you connect it the first time. If
the shifter is not working properly it might require new calibration as well. Please go
through the following steps:
1. Power on the wheel
2. Choose any platform mode (PS3/PC). Make sure your shifter is connected to the
wheel.
3. Press
“Start Button”
+
“Tuning Button”
at the same time
4. Bring the 7GS into neutral position and press the “Start Button”.
5. Enter reverse gear and press
“Start Button”
6. Enter 1st gear and press
“Start Button”
7. Enter 2nd gear and press
“Start Button”
8. Enter 3rd gear and press
“Start Button”
9. Enter 4th gear and press
“Start Button”
10. Enter 5th gear and press
“Start Button”
11. Enter 6th gear and press
“Start Button”
Shifter calibration finished. You can check the proper functionality with use of the PC
driver menu.
6_n
6_r
6_1
6_2
6_3
6_4
6_5
6_6
