FANATEC CSL, Manual

Page: 19 / 24

15 15
Clean only with a dry or slightly damp microfibre cloth. Using cleaning
solutions may damage your CSL Pedals Load Cell Kit.
CLEANING
5
The CSL Pedals Load Cell Kit must not be modified in any way, other than
what is explicitly described in this manual. Endor
®
AG expressly prohibits
analysis and utilisation of the electronics, hardware, software, and firmware
contained in this device. In case difficulties occur when using your CSL
Pedals Load Cell Kit, please use the following troubleshooting guide. You
will find further details and contact information on Fanatec.com/support/faq .
If the CSL Pedals Load Cell Kit is not working properly:
TROUBLESHOOTING
6
Problem description Solution
The PC driver or the wheel base does not
recognise the CSL Pedals Load Cell Kit.
Make sure that you have updated your wheel
base and CSL Pedals LC firmware to the
latest firmware version contained within the
latest PC driver which can be downloaded
from fanatec.com/driver .
Ensure that you are using the RJ12 cable
included with your CSL Pedals package.
Ensure that the RJ12 cables are plugged in
the correct ports of the CSL Pedals Load Cell
Kit module and the correct port of the wheel
base. See section 4.4 “Connections”
After
performing
a firmware update of the
CSL Pedals LC,
the manually calibrated
pedal positions are reset.
After performing a firmware update of the
CSL Pedals LC, the manually calibrated pedal
positions have to be manually calibrated
again. See section 4.5 “Tuning Options”,
“Manual Mode”