10
5. HEADPHONE
Jack
- Insert the stereo headphones’ 3.5mm(1/8”) plug
into the headphone jack.
6. DISC/TONE
- Associated with mode switch. When mode switch is in
DISC mode, you can rotate the control clockwise from 0 to 10 to
discriminate between metals. Unit discriminates the metal type with
different tones, you may hear a long tone, short tone or there may be
no tone. In TONE mode, unit discriminates the metal type with high or
low tones.
7. VIEW
METER
-The pointer will swing to the right as the unit has made
a detection.
Operation Instructions
DISC, TONE and ALL METAL are motion modes. You have to move the
searchcoil to find your target. While TARGET is a non-motion mode.
When searching, set operation mode to ALL METAL and SENS to 5.
Sweep your searchcoil as following picture, move the searchcoil right and
left in an arc line. It is better to keep the distance from searchcoil to the
ground about 1 – 5cm (closer to the earth for smaller target).
If there is a sound of “du-du” during moving, it indicates that there is a
metal object in the target area. In this case, you can use TARGET to
pin-point the object. Set mode switch to DISC or TONE to determine
which type of metal you have detected. The followings are the four
operation modes in detail.
4 OPERATING MODES:
Summary of Contents for MD1023
Page 14: ...14...