ENGLISH
Specifications:
Troubleshooting:
The following overview serves as an aid for quick troubleshooting. If you are unsure, contact the
manufacturer, the dealer or the corresponding specialist personnel.
If the specified corrections have not led to success, please contact our service staff. The contact
details can be found at www.musicstore.de
Model
Studio CU1 USB condenser microphone
Sound conversion principle
USB condenser microphone
Capsule
22 mm Electret Diaphragm Capsule
Directional characteristics
Cardioid
Frequency range
30 Hz – 18 kHz
Sensitivity
-32 dB (OdB = 1V/PA @ 1 kHz)
Equivalent noise level
< 22 dB, A-weighted
Max. SPL
140 dB (@ 1kHz≤1% T.H.D.)
Signal-to-noise ratio
68 dB
Sampling rate
16 Bit, 48 kHz
Required connector
USB (included)
Symptom
Troubleshooting
No tone
Check the USB cable for damage (cuts, extreme
kinks, etc.).
Check the wiring. Connectors must be fully
inserted and snap into place!
Arm the microphone in the DAW or activate direct
monitoring.
Check the sound settings of your operating
system. If necessary, select the microphone as the
input device.
The microphone may need to be levelled. Refer to
the software manual of the DAW (Digital Audio
Workstation) in question.
Delayed tone
Change the buffer size in the DAW settings. The
lower the number, the lower the latency. (Note:
with a low buffer size, the machine requires higher
performance. Depending on the computer, this
can lead to higher performance losses).
