7.0 MAINTENANCE & STORAGE
This FallTech Tripod should be kept clean and free from any dirt, corrosives, abrasive or any other material that
may damage it. Clean the tripod as necessary with a mild soap and water, rinsing thoroughly afterward. Do not
use other chemicals or solvents to clean this tripod. Allow the tripod to dry completely before storing. The built-
in pulley should also kept clean and free from any large debris that may inhibit its function. The pulley shaft
may be lubricated with a small amount of oil. When not in use the FallTech Tripod should be stored in its
Tripod bag in a clean, dry area.
1.
Inspection must be carried out by a competent person trained in the inspection and replacement of the
system. A record log of all servicing and inspection dates for this system should be maintained by the
company safety officers at intervals of no less than twice per year. This system and all components must be
withdrawn from service if subjected to fall arresting forces. Only original FALLTECH Replacement parts
are approved for use in this device. Contact your FALLTECH distributor or FALLTECH Customer Service
Department at (800) 719-4619 if you have any questions.
2.
Maintenance and storage of equipment shall be conducted by the user’s organization in accordance with
FALLTECH instructions. Unique issues which may arise due to conditions of use shall be addressed with
FALLTECH.
3.
Equipment which is in need of or scheduled for maintenance shall be tagged “DO NOT USE” and removed
from service.
4.
Hardware should be wiped clean with a rag to remove dirt and grease. Lubricate with a light oil to insure
good working order and protect against corrosion. Wipe off excessive amounts of oil to avoid the
accumulation of dirt.
5.
Store in a clean, dry area free from excessive heat, steam, sunlight, harmful fumes, corrosive agents and
rodents.
WARNING:
Do not use Fall Protection equipment that has not been maintained and stored properly.
8.0 INSPECTION
Inspection procedures for in field visual inspection:
1.
The FALLTECH Systems shall be inspected by the user before each use and additionally by a Competent
Person other than the user at intervals of no less than twice a year. If equipment is in a very harsh and/or
corrosive environment, additional inspections may be necessary. Detailed inspections must be recorded. A
comprehensive Inspection Checklist is included with all FALLTECH instructions..
