Backstop Installation — Size 4608
Maintenance
Only Type B1F backstops are furnished with grease-purged
seals which minimize the entry of taconite and other abrasive
dusts into the backstop. Unless specifically ordered otherwise,
Type B1F backstops are furnished with NLGI #2 bearing grease
in the seal housing cavities.
WARNING:
DO NOT fill cavities with grease if application is in
the food or drug industry, where grease could contaminate the
product.
To make use of this feature, pump NLGI #2 bearing grease
into the seal housing cavity through the seal grease fitting.
Periodically (monthly) depending upon the frequency and
degree of contamination, purge contaminated grease from
seal by pumping fresh bearing grease through the bearing
cage until it flows out along the shaft. Wipe off purged
grease.
Service & Removal
WARNING:
DO NOT attempt to service or remove backstop
before locking out power source and removing load.
Backstops must not be dismantled or repaired. Backstops are
nonserviceable components. Replace damaged backstops with
a new Factory tested backstop.
Remove backstop by applying axial force to the hub of the
backstop only.
The Falk Corporation, P.O. Box 492, Zip 53201-0492
378-102
3001 W. Canal St., Zip 53208-4200, Milwaukee, WI USA Telephone: 414-342-3131
August 2004
Fax: 414-937-4359 e-mail: [email protected] web: www.falkcorp.com
Supersedes 6-92
®
a good name in industry
Appendix B
•
Quadrive Shaft Mounted Drives
(Page 32 of 52)
Sizes 4407/M4407-4608/M4608
