Falcon U110138 - 03, User'S Manual & Installation Instructions

Page: 35 / 44

WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity before servicing. Check appliance is safe when you have finished.
33
4 Grill
4.1 To Replace the Grill Controller
DISCONNECT FROM THE ELECTRICITY SUPPLY.
n n
BEFORE SERVICING ANY GAS CARRYING
COMPONENTS, TURN OFF THE GAS SUPPLY.
Remove the control panel and hotplate (see 1.1 & 2.1).
Disconnect the wiring from controller. Remove the 2
screws holding the controller to the mounting panel.
Fit the new controller and reassemble in reverse order.
Check for correct operation.
4.2 To Replace the Grill Element
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Remove the grill pan from the grill chamber. From inside
the grill compartment, undo the 2 screws and washers
and remove the enamelled front shield from the grill
roof. Remove the 2 screws and washers securing the
grill element front support. Remove the screws from the
grill elements.
Carefully lift the elements out and, noting their
positions, disconnect the leads from the element
terminals.
If it is not possible to disconnect the leads in this way,
pull cooker forwards to gain access to the rear. Remove
the screws securing the electric cover to the back sheet,
and then remove cover and disconnect the terminals
from the rear.
Fit the new elements and reassemble in reverse order.
Check the operation of the grill.
5 Ovens
5.1 To Remove the Oven Inner Back
Main Oven
Open the main oven door. Remove the 4 screws and
washers securing the inner back to the back of the oven
(Fig.9-3). Carefully lift away the inner back.
Reassemble in reverse order, making sure that you fully
tighten the 4 screws and washers.
Tall Oven
Open the tall oven door and remove the 2 screws and
washers securing the inner back to the back of the oven.
Carefully lift away the inner back.
Reassemble in reverse order.
Check the door for correct operation.
5.2 To Change the Oven Fan
DISCONNECT FROM THE ELECTRICITY SUPPLY.
Pull the cooker forward to gain access to the rear.
Remove the screws securing the electric cover to the
back sheet and remove the cover. Disconnect the
3 terminals connected to the fan, noting their position.
Remove the oven inner back (see 5.1). Hold the fan
blade and remove the centre nut (left-hand thread),
2 brass washers, fan blade and circlip. Unscrew the fan
Fig.9-3
ArtNo.320-0020 Oven back fixing screws