27
Australia
Moving the Cooker
The cooker is very heavy. Take great care.
We recommend two people manoeuvre the cooker. Ensure
that the fl oor covering is fi rmly fi xed, or removed to prevent
it being disturbed when moving the cooker around. You will
need the levelling tool.
From the back tilt the cooker forward and remove the rear
half of the polystyrene base pack.
Repeat from the front and remove the front half of the poly
base. Pull the drawer out to its furthest point.
Lift up the ends of the plastic clips (one each side) to release
the catches holding the drawer to the side runners and at
the same time pull the drawer forward and away from the
side runners. For safety’s sake push the drawer runners back
out of the way.
Now LOWER THE TWO REAR ROLLERS.
First fi t the levelling tool on the hexagonal adjusting nut as
shown below.
Make 10 complete (360°) turns clockwise. (This means
turning and removing the levelling tool 20 times).
Make sure you lower BOTH REAR ROLLERS. There are two
adjusting nuts, one for each roller, at both the front bottom
corners of the cooker.
Unfold the rear edge of pack base tray. Open the grill door
and the Tall oven door. Grip under the facia panel and lift
the front of the cooker.
Carefully push the cooker backwards o
ff
the pack base.
Remove the pack base tray. Position the cooker close to its
fi nal position leaving just enough space to get behind it.
Do not use the door handles or control knobs to manoeuvre the
cooker. Use the hotplate and griddle bowl areas.
Levelling
You are recommended to use a spirit level on a shelf in one
of the ovens to check for level.
Place the cooker in its intended position taking care not to
twist it within the gap between the kitchen units as damage
may occur to the cooker or the units.
