WARNING – SERVICING TO BE CARRIED OUT ONLY BY AN AUTHORISED PERSON
Disconnect from electricity and gas before servicing. Check appliance is safe when you have finished.
33
OFF
OFF
PRO+
9. Servicing
1. General
1.1 Removing the control panel
Disconnect the cooker from the electricity supply.
Remove all control knobs. Open the oven door. Undo
the screws holding the oven beak to the cooker and
remove (Fig.9-1).
Remove the fixing screws on the underside of the
control. The control panel should drop down slightly.
It is held at each end by two holes in the top edge
(Fig.9-2) that locate on the tags on the inner panel.
Lift up the control panel so that it is clear of the tags
and pull the control panel forwards (Fig.9-3).
Disconnect the wiring from the rear. Lift the panel
clear of the cooker.
Replace all parts in reverse order.
When replacing any electrical connections refer to the
wiring diagram.
1.2 Removing the hotplate
Disconnect the cooker from the electricity supply.
Remove the pan grates and burner heads.
Remove the 10 screws (2 per burner) holding the
hotplate burners to the hotplate.
Remove the 8 screws holding the hotplate tray to the
cooker (Fig.9-4).
Taking care not to damage the burner heads, lift the
hotplate clear of the cooker.
Reassemble in reverse order, ensuring that the leads
are reconnected correctly.
Check the operation of each burner.
1.3 Removing the side panels
Disconnect the cooker from the electricity supply.
Remove the control panel. Undo the 3 screws securing
the plinth to the cooker and remove.
Situated below the edge at the panel front corner is
the lower retaining screw. Remove this screw.
Remove the side panel retaining screw on the upper
front edge, and undo the two fixings on the rear of the
side panel.
Remove the panel by pulling it away from the cooker.
Fig.9-1
Fig.9-4
ArtNo.272-0014 - 90 Pro+ pyro- Removing the control panel
OFF
OFF
PRO+
Fig.9-2
ArtNo.270-0019 - Proplus tags 2
Fig.9-3
