6
If the system is disarmed the door unlocks before and after remote starting the engine.
18) Remote start mode: Factory default = Alternator
To program the Remote Start Mode as Alternator or Tach.
RPM (TACH) Learning:
- Perform the Tach Learning before using the remote start for the first time
- Make sure the Tach wire(C4-1 Green) of the alarm system is connected to the negative of the
coil as shown in the wiring diagram
Before performing the RPM (Tach) learning turn off all electrical devices such as car stereo, FM
Radio or air conditioner. By doing so, the system will learn lowest RPM, which will make it
smoother and easier when using the remote starter.
Take the following steps to perform the RPM learning:
a> Shift the gear to the neutral position and pull up the hand brake.
b> Switch the ignition on and start the engine.
c> Wait until the RPM is running stably (normally vehicle’s stable RPM is 900-1,000.)
d> Press button 2 for 2 seconds. The hazard lights will flash for 2 seconds and then flash twice
to confirm that RPM is learned.
Important:
* Please make sure to set Start Mode Select as TACH (please refer to # 18 Remote Start Mode of
Programming Option Table).
* The Tach wire (Green) of the alarm system should be connected to the negative of the coil.
19) Crank time: Factory default = 600ms
Normally, older vehicles and diesel vehicles need a longer crank time to start the engine.
However, if the engine doesn’t start smoothly, please set the crank time longer.
*For diesel vehicles please try to program 1000ms in order make the remote engine start work
smoothly.
20) Engine running time: Factory default = 10 minutes
Depending on the programmed engine running time the engine will run for 10 or 20 minutes
and then shut down automatically.
21) Timer start: Factory default = 3 Hours
With the system armed or disarmed the Timer Start feature can be turned on or off as follows:
A) Turn on Timer Start Mode:
- Press buttons 1+4 once, the siren will chirp and hazard lights will flash once to confirm the
feature has been turned on for 24 hours.
- The engine will be started every 3, 6 or 12 hours depending on the selection of option feature
#21
B) To turn off Timer Start Mode Press buttons 1+4 once, the siren will chirp and hazard lights
will flash twice to confirm the feature has been cancelled.
Timer Start mode will be cancelled in the situations below:
* When remotes engine start is used.
* If the ignition has been turned on with the system disarmed
* The doors are opened with the system armed
22) Alternator voltage: Factory default = 4.5V
This setting should be left set on the default setting of 4.5V unless advised otherwise by the
technical department of supplier.
23) Channel 3 output: Factory default = Disabled
The channel 3 output is often applied for total closure/comfort closure and the operation is
as follows:
Summary of Contents for Predator EVO4 V2
Page 9: ...9 F Wiring Diagram...
Page 10: ...10 G Wiring Note 1...
Page 11: ...11 H Wiring Note 2...
