SECTION 3 - SERVICING and
MAINTENANCE
BEFORE ATTEMPTING ANY MAINTENANCE, DISCONNECT APPLIANCE FROM THE MAINS.
When ordering spares, please quote model number, serial number and voltage as detailed on data plate at
unit rear.
Remove specific parts as detailed below.
3.1 CONTROL PANEL
a) Remove fixings from upper flange of panel. i.e.
below front hob overhang.
b) Remove three fixings below control panel.
c) Undo and remove knob from sliding tap at front and pull out control panel.
Note
: If any current is not within stated tolerances, the cause must be investigated and rectified.
Phase Min (A)
Max (A)
Actual (A)
L1
5.87
6.86 6.52
3.2 OPERATING THERMOSTAT
a) Remove control panel as detailed in Section 3.1.
b) Undo fixings on bracket that secure thermostat phial to pan base.
c) Pull off thermostat connections, noting locations.
d) Pull control knob off. Remove two fixings that secure thermostat to panel.
e) Upon refitting, ensure insulating sleeve covers length of capillary tube.
3.3 PILOT LAMPS
a) Remove control panel as detailed in Section 3.1.
b) Pull off connections to lamp.
c) Undo nut that secures lamp. Pull lamp out and fit replacement.
3.4 HEATING ELEMENTS
a) Remove control panel as detailed in Section 3.1.
b) Remove side panels by undoing two fixings on underside and two rear fixings.
c) Pull off element connections.
d) Undo six nuts that secure element box.
e) Pull box down to remove element. Install replacement element .
