INSTALLATION
Check the appliance is electrically safe and gas sound when you have finished.
26
6 mm² max
230 Vac 50 Hz
N
L
10 mm² max
Fig.7-24
Plinth
Fig.7-26
Front left
Front right
Locating
washer
Plinth
Pin
Fig.7-28
Fig.7-27
L1
N
L3
L2
3N ac
230/400 V 50 Hz
6 mm² max
10 mm² max
6 mm² max
Fig.7-25
Electrical Connection
The cooker must be installed by a qualified electrician, in
accordance with all relevant national and local regulations.
Note:
The cooker must be connected to the correct electrical
supply as stated on the voltage label on the cooker, through
a suitable cooker control unit incorporating a double-pole
switch, having a contact separation of at least 3 mm in all
poles.
n
n
The cooker MUST NOT be connected to an ordinary
domestic power point.
Access to the mains terminal is gained by removing the
electrical terminal cover box on the back panel. Connect
the mains cable to the correct terminals for your electrical
supply type (
Fig.7-24
and
Fig.7-25
). Check that the links are
correctly fitted and that the terminal screws are tight. Secure
the mains cable using the cable clamp.
Final Checks
Hotplate Check
Check each burner in turn (refer to the
‘Hotplate Burners’
section at the front of the instructions).
Grill Check
Turn on the grill control and check that the grill heats up.
Oven Check
Turn on the ovens – check that the oven fans start to turn and
that the ovens start to heat up.
Final Fitting
Fitting the Bottom Panel
Open the left-hand oven door.
On the front on the cooker base there are two mounting
plates. Remove the three fixing screws from each plate.
Fit the retaining brackets to the mounting plates and refit the
screws
(Fig.7-26)
. DO NOT tighten at this stage.
Tilt the bottom of the panel slightly to locate the lower slots
onto the washers
(Fig.7-27)
. Now rotate the panel to fit over
the upper pins
(Fig.7-28)
.
Using the two screws provided, secure the bottom panel onto
the brackets. DO NOT tighten at this stage.
Adjust the bottom panel to align it with the door panels.
When it is positioned correctly, use a suitable flat open ended
spanner to tighten the bracket screws, and then tighten the
bottom panel screws.
Customer Care
Installer:
Please complete your details in this guide, inform
the user how to operate the cooker and hand over the
instructions.
Thank you.
Summary of Contents for Mercury 1082 Dual Fuel
