3
vertical handle to rear. Push plate back until rear flange is fully against brander bars to ensure
that any food residue drains into drip tray.
The plate may require to be oiled before use with some food items.
The unit has been tested to ensure optimum safety and performance is achieved using just one
griddle plate. As with all equipment, optimum performance will depend upon food type, quality and
quantity with cooking times adjusted to suit.
2.4
LIGHTING THE BURNERS
2.4.1 Manual Ignition of Pilot
See Figures 2, 3, 4, 5, 6 and 7. Proceed as follows:
a) Push tap in and turn anti-clockwise to pilot position.
b) Hold tap fully in. Insert hand-held gas lighter in hole relative to tap being operated.
Repeat procedure until pilot flame ignites.
c) When pilot is lit, continue to hold tap fully in for 20 seconds before release. If pilot
goes out, wait 3 minutes and repeat from
(b)
.
d) Repeat for remaining burners using other ports and respective gas taps.
2.4.2 G3425, G3625, G3925, G31225, G31525 Models
Piezo Ignition
a) Push tap in and turn anti-clockwise to pilot position.
b) Hold tap fully in and press igniter button.
c) Observe, through the slots, that pilot is lit.
d) If not, press ignition button repeatedly until pilot does light.
e) When pilot is lit, continue to hold tap fully in for 20 seconds before release. If pilot
goes out, wait 3 minutes and repeat from
(b)
.
f) Repeat for remaining burners using other ports and respective gas taps.
If piezo igniter is non-functional, then back up ignition is achieved by manual ignition
(See Section
2.4.1)
.
Figure 2 - Control Knob Details
2.4.3 Lighting of Main Burner
a) When pilot is established, push tap in and turn anti-clockwise to HIGH position
(large symbol)
to light burner.
b) The tap can be adjusted between HIGH and LOW depending upon requirements.
If a burner is extinguished intentionally or otherwise, NO ATTEMPT to re-light it should be
made until at least 3 minutes have elapsed.
2.5 TURNING THE BURNER OFF
Refer to Figure 2. Proceed as follows:-
For Short Periods
To turn off burner leaving pilot lit, push in knob and turn it clockwise to pilot position.
Never leave products that are being used unsupervised and always turn products fully off at the
end of service.
