894
680
185
140
257
317
829
879
15
60
200
c) Clean the plug and body with a soft rag and
re-grease with an approved high temperature
lubricant. Apply the grease sparingly, DO NOT
block the gas passageways of the plug and body.
d) Ensure that the plug is inserted intothe body in the
correct position for operation.
e) Secure the end cap to the body. Note that the fixing
holes line up in one way only.
Note
Plugs and bodies are machined as matching pairs
and are thus non-interchangeable. To avoid mix-up,
clean one tap at a time.
3.9 GOVERNOR (Natural Gas Appliances Only)
This component requires little attention however, the
air breather hole should be cleaned regularly during
routine maintenance. Access to this area is achieved
by removing the top cover. The hole is located 15mm
off-centre and may be cleaned by blowing or with the
aid of a piece of soft fuse wire.
3.10 FILTER UNITS
a) Undo the two compression nuts and remove filter.
b) Replace in reverse order. Ensure that the end
marked OUTLET is fitted on the filter to pilot pipe.
3.11 PLINTH
When an appliance is required to be mounted on a
plinth, the areas indicated in Figure 10 MUST be kept
clear for aeration purposes.
SECTION 4 - SPARE PARTS
When ordering spares, always quote the unit type
and serial number. This information is on on the data
plate attached tothe appliance. Details o
f parts
available accompany this document pack.
Figure 10
