© Raymond & Lae Engineering, Inc. 2011. All rights reserved. RLE
®
is a registered
trademark and Seahawk™, Falcon™, and Raptor™ are trademarks of Raymond & Lae
Engineering, Inc. The products sold by Raymond & Lae Engineering, Inc. are subject to
the limited warranty, limited liability, and other terms and conditions of sale set forth at
http://rletech.com/RLE-Terms-and-Conditions.html.
v1.2
4/2012
104 Racquette Drive
Fort Collins, CO 80524
800.518.1519
rletech.com
4
Connecting the Inputs
The four non-isolated analog inputs are available on channels 1,2,3, and 4.
Analog input channels can be individually configured through the F3400/F1000 to
monitor a 4-20mA signal. To connect to an input, refer to the following sensor
wiring diagrams:
T120D Temperature Sensor
TH140D Temperature/Humidity Sensor
SeaHawk LD5200 Distance-Read Leak Detection
SeaHawk SD Spot Detector
5
Connecting the Relays
Relay outputs may be used to unlatch doors, signal annunciators, signal web
cameras, and to turn on auxiliary equipment such as exhaust fans. Relay outputs
are Form C (SPDT). Relays may be configured, through the F3400/F1000, for
Normally Open (NO) or Normally Closed (NC). See example below.
6
Configuring Inputs and Relays
7
Completing the Installation
Once you have completed the tasks in this quick start guide, the F-Series can
communicate over the network and monitor the inputs you configured.
Consult the
F-Series User Guide
at http://www.rletech.com for information about
configuring:
System information
Email notification
