background image

IMPORTANT INFORMATION

Warranty Policy Shortlist

Warranty does not cover :-

Correcting faults caused by incorrect installation of a product.

Where an engineer cannot gain access to a site or a product.

Repeat commission visits.

Replacement of any parts where damage has been caused by misuse.

Engineer waiting time will be chargeable.

Routine maintenance and cleaning.

Gas conversions i.e. Natural to Propane gas.

Descaling of water products and cleaning of water sensors where softeners/ conditioners are not fitted, 

or are fitted and not maintained.

Blocked drains

Independent steam generation systems.

Gas, water and electrical supply external to unit.

Light bulbs

Re-installing vacuum in kettle jackets.

Replacement of grill burner ceramics when damage has been clearly caused by misuse.

Where an engineer finds no fault with a product that has been reported faulty.

Re-setting or adjustment of thermostats when unit is operating to specification.

Cleaning and unblocking of fryer filter systems due to customer misuse.

Lubrication and adjustment of door catches.

Cleaning and Maintenance

• Cleaning of burner jets

• Poor combustion caused by lack of cleaning

• Lubrication of moving parts

• Lubrication of gas cocks

• Cleaning/adjustment of pilots

• Correction of gas pressure to appliance.

• Renewing of electric cable ends.

• Replacement of fuses

• Corrosion caused by use of chemical cleaners.

Summary of Contents for E3478

Page 1: ...stration of the operation and cleaning of the appliance IT IS MOST IMPORTANT THAT THESE INSTRUCTIONS BE CONSULTED BEFORE INSTALLING AND COMMISSIONING THIS APPLIANCE FAILURE TO COMPLY WITH THE SPECIFIED PROCEDURES MAY RESULT IN DAMAGE OR THE NEED FOR A SERVICE CALL PREVENTATIVE MAINTENANCE CONTRACT In order to obtain maximum performance from this unit we would recommend that a maintenance contract ...

Page 2: ...ion systems Gas water and electrical supply external to unit Light bulbs Re installing vacuum in kettle jackets Replacement of grill burner ceramics when damage has been clearly caused by misuse Where an engineer finds no fault with a product that has been reported faulty Re setting or adjustment of thermostats when unit is operating to specification Cleaning and unblocking of fryer filter systems...

Page 3: ... must be installed upon a firm level floor in a well lit position It requires to be secured to this surface The oven can be positioned to within 150mm of a combustible wall 1 3 ELECTRICITY SUPPLY The unit is designed to be connected to an AC supply only i e single phase or 3 phase 4 wire The cable entry is located at rear of appliance 25mm conduit The supply must be installed using a suitable isol...

Page 4: ... door is securely close If the seal is damaged remove the seal by pulling away from the door Replace seal by firmly pushing the new seal into the door frame until fully home To adjust door catch Undo lock nut on the door catch Adjust catch Tighten lock nut 3 2 ELECTRICAL MAINTENANCE Warning Before attempting any electrical maintenance SWITCH OFF THE MAIN SWITCH and take steps to ensure that it is ...

Reviews: