9
3.1.4
Oven Burner - To Replace Injector
(from front of oven Refer to Figure 9)
Remove oven shelves and base plate.
Undo fixings and remove burner plate.
Undo fixings and remove pilot shield from back wall of combustion
chamber.
Remove burner by pushing it back out of mounting and draw it forward
until pilot assembly and gas pipe can be removed from burner.
Undo fixings and remove existing injector.
Insert and screw-in replacement injector.
Refit burner.
Re-assemble in reverse order.
3.1.5 Setting Oven Burner Pressure (Refer to Figure 10)
a)
Open electric terminal box at rear.
b)
Connect manometer to valve pressure test point as detailed in
Figure 10.
c)
Adjust pressure using valve governor indicated to value stated in
Section 1.9.
3.1.6 Pilot Injector
When carrying out procedures detailed in Sections 3.1.3 and 3.1.4. Remove
pilot pipe to access injector.
3.2
REMOVAL OF CONTROL PANELS
Various panels are removed as follows:
3.2.1
To Remove Facia Panel
Remove control knob
(s)
. Open oven doors and undo fixings along underside and top. Pull facia panel
forward while slightly easing bottom edge upward to remove.
3.2.2
To Remove Open Top Hob Components
Remove pan supports and burner heads complete with aluminium bezels and venturi that sit loosely
upon injector holder.
The hob is retained by ball stud fixings at each corner. Lift hob clear to access burner support brackets.
3.2.3
To Remove Hob
Remove fixings that secure front hob support and fixings that secure flue to back panel. Lift full hob area
- including flue - clear of unit.
3.3
BURNERS
3.3.1 Open Top
Remove hob components as Section 3.2.2. Undo burner pipe compression fitting.
Undo injector holder fixings. Withdraw burner body.
Replace in reverse order.
3.3.2 Oven
Refer to Section 3.1.4.
3.4
CLEANING
3.4.1 Burners
Burners should be cleaned periodically to maintain maximum performance. Clean open top burners as
detailed in User Instructions. Additional burners are best cleaned with a wire brush; port blockage should
be freed using a metal broach, any loose material being shaken out via burner shank. Ensure burners
are dry and free from any cleaning material before replacing.
Check adjustment as detailed in Section 1.
Summary of Contents for DOMINATOR PLUS G3106 Series
Page 6: ...6 Figure 1 Figure 2 Figure 3 Figure 4 Figure 5 Fixings...
Page 12: ...12 Circuit Diagram...
Page 13: ...13 Wiring Diagram...
